Jump to content

vlad-gorneanu

Dormant
  • Posts

    3
  • Joined

  • Last visited

    Never

vlad-gorneanu's Achievements

0

Reputation

  1. Blizz, I only have 2 plug-ins but none enabled. See below.
  2. Hi all, I have an Ultimaker 2 for a about a week now and I printer around a half of dozen things before I encountered this issue. The cooling fans do not work automatically anymore. Before, when I wanted to print something , they started working as soon as the print was starting but now I need to go to Tune(while printing) , Fan Speed and choose the % I want. If I get a higher % like 80%-85% , the fans work for a couple of minutes and they automatically go down to 5% or 7% and stay they until they don't work at all. I manually set them up again and they go down by themselves. The only changes before a non issue status of the printer and this issue is that I tried to update the printers firmware. Nothing else. Note that before saving the mode on the SD card in Cura, I always make sure to check that "Enable cooling fan" is ON. Can you please help me? Have you encountered this issue? Thanks.
×
×
  • Create New...