Jump to content
Ultimaker Community of 3D Printing Experts

sharkfan94

Member
  • Content Count

    2
  • Joined

  • Last visited

    Never

Community Reputation

0 Neutral
  1. No, I'm saying that cura used to print perfectly without fail for me. It would home X and Y, go up 15mm then slowly move down to the middle or the bed. But then maybe a week ago it started to move Y out as far as possible, homed X then would just start the print at that location. I have tried multiple files and each ends up being a glob about 1 inch long by 1/8 of an inch wide. I don't know how to describe it other than that it just prints a big glob in a very small area instead of starting the print like it used to.
  2. So I almost exclusively print from an SD card so that my laptop is free. Up until a few days ago everything was working fine. But now when I start a print a slice in cura my Simple just goes to the from left corner and just proceeds to print a glob in the corner. It hasn't done this before and I can't seem to find any info about it. Does anyone have any suggests or thoughts as to what might be causing this?
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!