Hi,
I received my new UM 2 a few days ago and have yet to make a successful print.
At First, the unit was making load noises on startup. I discovered that the rear shaft had popped out from the side during shipping.
I was able to level the table and feed material and had several failed prints (the material seems to keep globing up on the extruder and the pulls the print off the table. I tried both PLA and ABS, with the same result.
During a material change, the feeder jammed up. I couldn't get the material out. When I looked at it, it looked the feeder was going backward (trying to push it out when it should have been trying to reload it). I took it apart and cleaned it out. After putting it back together (material now out), the feeder is definitely going backwards.
I did a factory reset and it is still going backwards (it is trying to push it out on material load, both the initial low speed and the secondary high speed).
Does anyone know how to fix this?
Thanks,
T