Jump to content

super-grover

Dormant
  • Content Count

    12
  • Joined

  • Last visited

    Never

Everything posted by super-grover

  1. I need to replenish my filament supply.... does it matter where i get my abs / pla from ? Any suggestions for cheaper prices?
  2. I cleaned out the feed and increased the flow of material and that seems to have done the trick! Thank you for your help.
  3. That was actually my first thought.. I changed the nozzle and those prints were with a new nozzle...
  4. I tried to slowing down the print to 50mm/s and 240C and I get the same result. I switched the material to ABS, but still seam to be getting the same result and printing @ 260C with 110C table... Any ideas?
  5. I need help trying to figure out why I am getting such a bad quality print...
  6. I used glue. The piece I was printing was large and flat. The piece sticks to the glass and cracks when it cools down. I will try using hairspray next time. I have never used painters tape... would this help?
  7. I was printing some large pieces using ABS and when the piece was finished a few shards of glass peeled off with the finished piece. Now i have a chipped print bed... Can i just go to any hardware store that has 4mm tempered glass and have them cut the right dimensions? How can i prevent this from happening in the future??? Thanks!
  8. My ultimaker 2 is having a problem locating itself. I had move the head to remove a piece of filament, but now when I turn on the machine I get a grinding noise when the printer tries to go to the set position. How do I get this from stop happening?
  9. I figured out the problem... I went to Expert setting and selected 3% fill material. I was able to just pull off the support. Thanks again for reading...
  10. Hi all, I was wondering what settings are best for the highest level of accuracy. I can sacrifice speed, but I want to make sure all parts fit. Thank you for your advice.
  11. I have been having issues with removing the support material. I am printing a hollow cylinder type product, but the support material attaches to the piece inside and it becomes very difficult to remove. I have also printed this piece on the side but the support material on the outside also gets stuck... I am printing in PLA using the high quality print button with support material. Thank you for reading!
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!