robbiegiggs

gr5, I don't have a pic of the counterbore feature I mentioned above but I do have a pic of what I think is the same issue on a different part. See attached... I can' not get any support material to fill under the overhang on this part. I've got the "Everywhere" option selected. Overhang Angle is zero. Please note, I'm using Cura thru the Repitier Host software. Is there any way I can upload the STL file in question to see if any of you can create the support material I need? Thanks Robert

Sorry I haven't gotten back to you. I'll try to get pics tomorrow. Thanks

I've got a part with two counter-bores in the bottom surface. I have enabled support at 45 degrees and 20% in order to get a flat surface. The first couple of layers, it's fine but in the remaining layers, I only get half of the support (when looking down on the part). Anyone know what's happening?