Jump to content

njeester

Member
  • Posts

    6
  • Joined

  • Last visited

Personal Information

  • 3D printer
    Ultimaker S5 Pro Bundle

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

njeester's Achievements

0

Reputation

  1. I have a Material Station with a blocked bowden tube with PVA. I have tried the advice on the help pages to no avail. There's a blockage to all the tubes deep inside the station (approx 24cm in measured from bay F extruder 2). The material used to try and clear the jam does not appear at the back. Is it possible to partial dismantle the machine to investigate and fix? Some advice & instruction would be useful. Thanks
  2. Its happened with different print jobs. This is this second time I think. Its printing again now. And the previous failed print printed fine the second time. Thanks for your help, i'll do as you suggest.
  3. Also I use a UPS to smooth out glithces in the power supply and there been no power fluctions.
  4. No, not that. I sent the print job over the wireless network.
  5. Can anyone through any light on whats happening. A couple of times the printer just stopped and says Failed with an big ! , and says confirm removal. Theres no error code, just as shown below. After removing the failed print and rebooting the system, I can start another print OK. Thanks
  6. The connectors are available here: http://www.technobotsonline.com/connectors-and-headers/jst-and-similar-connectors/jst-xh-2.5mm-leads-and-connectors.html
×
×
  • Create New...