rcarrier31

Tried that same thing, printed at 0.1mm

.02, it is something in the firmware causing it to either mirror, or just double the size of the z axis, i had another printer before this one, and i am printing the same parts, and the z is double on every one. It does not have a stable bed on the z axis, the one i had before did, so i am thinking it is something to do with that.

#define DEFAULT_AXIS_STEPS_PER_UNIT {78.74,78.74,800,100}

Z Hop is set to 0.0

where is the zhop settings?

Sorry guys it is the z axis that is double the size. You think it could have something to do with the table moving up and down?

I think the problem is, it is mirroring the x axis somehow, just cant find the solution.

I have tried several files, they all do the same thing. https://www.youmagine.com/designs/belt-tensioner

Ok just downloaded a file from here, same thing x double the size. Is there a setting for that?

OK i just printed a wing nut in layer view it is 13.74. and it comes out a little over 27.

I have tried, another member on here helped me finally get it going, i dont have that much exp with 3d printing.

The stl file.

Does anyone ever download files from here, for some reason the x is always double the size, i am assuming there is a difference in the gcode?

OK got it guys, thanks for your help, its finally printing well, and it was much easier to do it in the firmware, versus moving the wires, its a pain to get to the controller, Once again thank you guys.

Yea when i tell it to autohome, everything works just fine, but when it goes to print the z axis goes to the bottom.

Well i thought everything was good, until i goto print, it moves the table all the way to the bottom, and starts the grinding.

Yes that got everything working the way it should, thank you again for your help & patience.

Got the X axis working, the y is still going the wrong way, thanks for your help.

Got it from the dealer, and the code is 33

>>>m119 SENDING:M119 Reporting endstop status x_min: open x_max: TRIGGERED y_min: TRIGGERED y_max: open z_min: open z_max: open

No when the x axis goes to the left, the endstop does nothing, stuck on that right now. And i meant to say it is supposed to home at back left.

Phone is being stupid cant upload a picture, but when the x axis goes to the right, i can hit the endstop switch and it works, when it goes to the left, it does not work.

Its a makerbase 1.0

OK set X_HOME_DIR -1, it goes left now, but the endstop does not work.It hits it and tries to keep going

Yes everything is moving in the right direction, according to pronterface.