Jump to content

thebagmaster

Dormant
  • Posts

    2
  • Joined

  • Last visited

    Never

thebagmaster's Achievements

0

Reputation

  1. Thanks everyone, was not too worried as Cerberus pointed out after a few layers this is all but gone. I shall try your suggestions.
  2. Greetings Everyone! I recently purchased an Ultimaker Original+ and went through the bed leveling wizard. I have done quite a bit of tweaking to try and get the first layer just right on some of my smaller prints. I tried a large print and realized that the first layer varies quite a bit in the middle of the glass, odd. Anyways, any help would be appreciated. Thanks. PS: PLA 195C 50C bed 100%flow 50mm/s speed 0.25mm Layer Height
×
×
  • Create New...