Jump to content

daan-goedkoop

Dormant
  • Posts

    2
  • Joined

  • Last visited

    Never

daan-goedkoop's Achievements

0

Reputation

  1. 1. Wouldn't the ultimaker keep track of the f value, adding up each value it reads? no idea how this is done, so this is just guessing. 2.I analysed a Cura sliced gcode file and looked at each line segment of a line, if you know what i mean. there I noticed some differences. Lets say all the line segments belong to the same type of line (eg. grid, support or perimeter). 3. Off course, thanks!
  2. Hi guys, I'm wondering if someone could advise me. For a project I'm building a slicer in grasshopper that converts non-closed lines (no contours) to gcode - kinda like the doodle 3d app does - in combination with regular slicing for closed lines (contours). I have a few questions of which I could use the answers . - Cura's feedrate is given in absolute measurements. Is there anything against relatives? - Feedrates seem not to be consistent (in Cura). Sometimes I see small(!) differences when I divide the feedrate by its corresponding line length. Is this difference due to set tolerances or is this on purpose? - What is a reasonable percentage of overlap for solid and grid infill lines over perimeters? Thanks a Million! Grtz, Daan
×
×
  • Create New...