warmbloed

Hello 3Dnerd, I am indeed using white PLA, the roll is about 5-6 months old, and was stored in an airtight container with a moisture eater. I would raise the temperature, but the strange thing is that the bottom layers are absolutely fine but it is only the top that appears to have this issue, almost as if something has changed halfway through the print. I will retry tomorrow with a higher temp. as far as I can tell there is no major difference in technology or mechanics between the UM1 and 2, but I may be wrong on this as I have only seen the UM2 in videos so far.

Hello everyone, I recently started getting some under extrusion issues in my prints, I have had issues with prints not holding water before, however I have never had an issue this big before. The nozzle has been cleaned recently, using the 'atomic' method, but also by heating the heaterblock and nozzle assembly and blowing compressed air through backwards. Some photo's: https://www.dropbox.com/s/mu41ogai6q63t84/IMG_1730.JPG?dl=0 https://www.dropbox.com/s/bcu33zgt0wjys3x/IMG_1731.JPG?dl=0 STL files are treads by LoialOtter on thingiverse: http://www.thingiverse.com/thing:35668/ printed using the default 'fast'settings in Cura for the Ultimaker original. I hope I have provided enough information, if not I'd be happy to provide more as needed. Kindly, Warmbloed