Jump to content

cigoler

Member
  • Content Count

    2
  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. Sorry the bed does heat up, but the actual temp display doesn't update.
  2. I've followed the instruction from here; https://ultimaker.com/en/resources/19484-stopped-temp-sensor following a problem when starting prints of a temp sensor problem. So i've swapped Temp 1 and Temp 3 and heating the bed doesn't bring up an error - but it also doesn't increase the temperature of the bed it stays stuck at 27 degrees. When I then try heating up the nozzle I get bed temperature error. The instructions aren't super clear about this. Does it mean it's the sensors fault or the main board?
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!