Jump to content

nubi

Dormant
  • Content Count

    1
  • Joined

  • Last visited

    Never

Community Reputation

0 Neutral
  1. hello, used the same lcd on my ultimaker 1 but it just keeps beeping and the light of the lcd just flashes, did i forget something, is there another pinout for that displaymodule (with sd) i use the board in version 1.5.6 i think, and original firmware that comes with cura lastest version. the display works fine with the ramps 1.4 electronics and teacup firmware. so i understand this seems to be the same problem as described above, bit there are 2 cabels that connect to the backpane of the lcd, wich one should be switched by 180? the one cloaser to the encoder? br
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!