Jump to content
Ultimaker Community of 3D Printing Experts


  • Content Count

  • Joined

  • Last visited


Community Reputation

0 Neutral
  1. Further to the OP's question above, what is going on now in the right hand side of cura now? The Build area shows as being half the width of the clip (as circled in this picture), however, this is not the case on the opposite side. I could have sworn this was not the case previously.
  2. Hello folks. I've recently upgraded to 15.01 and have noticed that the estimated build time text is missing along numbers in the scaling menu as seen in the following link. http://imgur.com/a/ndxeN Does anyone know if anything on my windows computer could be causing this? If you need my specs, I will post them below, however, I have not experienced this with any previous verisons. Many thanks for your help!
  • Create New...