I have just downloaded and installed the new version of Cura on a freshly formated PC. I have a issue when my PLA is retracted it just gets stuck, so I turn retraction off. However, it is still retracting over half a circle of my wades extruder at least once every layer, unless its a very very small part. None of the retraction settings are checked within the >preferences>settings. The only thing i can think of doing to get around it is to enable retraction and set minimal distance before retraction to a very large number and retraction material amount to a very very low number so it it does retract it doesnt retract soo much. Am i missing something in the settings? Is this a bug?