Hello guys, you probably heard about this problem, pleasee see picture:
As you can see the first layers are very thin and unstick.
I tried:
-Print a default part (A part with CURA setting that used to print perfect)
-Clean the bedplate.
-Adjust the bedplate (many times with many techniques)
-Clean the nozzle (Athomic Bob, and I also dissassembled the whole thing and put the nozzle into a oven at 400 *C - I can see light through the nozzle)
-Tried with different filament (Original Ultimaker PLA and GlowFill Colorfabb)
Points to consider:
1-I used to have this problem, but I solved it adjusting the bedplate + Athomic Bob.
2-The problem is worst and more likely with Glowfill PLA than others.
3-My nozzle is a bit flattener (because of Glowfill abrasive nature).
Tomorrow I will Try:
-Try with a complete new filament.
-Repleace the nozzle kit.
Any advice will be apreciated.
Kind regards.
EDIT:
SOLVED THE PROBLEM repleacing the PTFE insulator and NOZZLE.
I also adjusted the height bethween the PTFE and Isolator in 1mm.
Now is printing like the first day, I will try to find the Olsson Block, I would like to try the colorfabb XT which according to the supplier is also abrasive.
Regards