Jump to content

hellfingers

Dormant
  • Posts

    3
  • Joined

  • Last visited

Everything posted by hellfingers

  1. hello everybody, sorry for the late answer... after have checked the cable, the motherboard was guilty ... i've taken the UMO's and now, my UM2 is ok... thanx to all.
  2. thank you for your precious advice Gr5,.. the only things that were not checked are the bed cable and the mother board, the bed and the pt100 came from my UMO+, she printed about 3h00...these parts are new..I will check my motherboard as soon as possible..Mostly i've seen that the error came when you put on the UM, mine begin the print and sometimes it's ok, sometimes not.. i hope it is the cable.. thank u again.
  3. Hello to all, i have a problem with my UM2 bought on 2014. i have both errors temp (bed and sensor). i've changed the bed and the pt100 (taken from my UMO+) and put the new firmware but it's the same shit. Some prints go the end but some not, in general mostly not. Do i need to change the mainboard ? thanx...
×
×
  • Create New...