Jump to content

matthew22

Member
  • Content Count

    7
  • Joined

  • Last visited

Community Reputation

0 Neutral

About matthew22

  • Birthday 10/09/1998

Personal Information

  1. i figured it out guys thanks heaps for all your help
  2. dose it work with a DIY heated bed beacuse normal software dosnt I don't think I used this http://marlinbuilder.robotfuzz.com/
  3. dose it work with a DIY heated bed beacuse normal software dosnt I don't think
  4. the thing is I have used costem marlin hex builder to make firmware beacuse I have a DIY heated bed so I think I will try build another one and see what I can do thanks for reminding me haha
  5. hey everyone i bought a Ultimaker with inverted axis a while ago but it doesn't fit where i want to put it because the steppers are sticking out and i have put it back to original form on the inside of the case but that reversed the way it moves and was wondering how to put it back?
  6. I have a Ultimaker original and I have put the second extruder on but the second is much higher than the other and when I losened it alittle it stated leaking I cant tighten the other anymore to make it higher I was going to try heat proof lock tight and make it so I can loosen it with out leakage to make it level but I was wondering if anyone had any ideas first and I have also tryed Teflon tape aswell.
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!