indefix123

The firmware for the UMO+ included with the Cura 3.6.0 release does not function properly on UMO+ the problem is that the controller screen becomes illegible i.e. becomes blue. I had to load a previous firmware from an older Cura version 15.04.06 to make it work.

Hi mekks well the not so funny thing is I also get these black squares did you manage to solve the issue?

I think we have exactly the same kit, short shafts of the X and Y motors, missing 20 nuts while there were far more lock nuts also one connector from the hot bed was missing or it was different I am not near the printer at the moment to check and the ultimaker board has connectors without screws to fix the cables.

Also I have the same issue, I was able to fix the pulley to the shaft with set screw just touching the edge of the shaft.

Hi peetersm, thank you for the photo I think I have exactly the same cable color coding.

Would it be possible someone to post a picture from an assembled board of umo+ in order to find out were its cable goes?

Hi Bryanzd check this forum page for the PT100 plug eventhough I cannot confirm its working. http://umforum.ultimaker.com/index.php?/topic/10240-new-terminal-block-on-recent-um-kit/

Hi I have exactly the same issue