Jump to content

lrvick

Dormant
  • Content Count

    4
  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. Can the printhead assembly of a UM2 be dropped into the X/Y rods of a UM1 ? Are the sizes/offsets all the same? Was wondering about the sanity of dropping in something like this: http://www.ebay.com/itm/0-4mm-Nozzle-Hot-End-Print-Head-Kit-Extruder-for-Ultimaker-2-UM2-f-3mm-Filament-/221744939292?pt=LH_DefaultDomain_0&hash=item33a107411c
  2. Alignment is dead on and everything is tight (I have been checking it frequently). It does seem the bearings are just a loose fit in the wood housing. I suppose some epoxy would probably do the job though that really feels like a dirty hack. That said, I can't even print a replacement housing the way it is running now. Epoxy it is. Anyone know where to source these exact bearings (mcmaster or otherwise) in case I muck them up too much for transfer into a future replacement enclosure?
  3. This happens frequently on my new UMO+ and has ruined several prints including one yesterday. After 13 hours of perfect printing the X bearing finally slid and fell into the left side of the sliderblock past the wall thus tilting the printhead. Can I drop in a UM2 style sliderblock like this? http://www.ebay.com/itm/like/361113040900?lpid=82&chn=ps Or perhaps has anyone printed any drop in slider-block alternatives with success that have a better lock on the linear bearings? Open to any ideas.
  4. Anyone know if the v2.1.1 pcb (powered by 9a 24v meanwell) has a 1A+ to spare on the 5V rail for a RasPi? If so, where would be the optimal hookup point?
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!