Jump to content
Ultimaker Community of 3D Printing Experts

StenDan

Dormant
  • Content Count

    2
  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. There are only a few places that they do not touch, and only on one side. see picture. Cura settings come:)
  2. Hello I am not sure if this is a hardware or a software problem. When I print a test circle with a wall thickness of 0.8mm then, it is not everywhere that the two walls touch each other. I have tightened all belts and calibrated parallelism on small rods Printer: Ulitmaker orginal + Design tool: 123D Design Slicing software: Cura Cura settinge see pic. thank you in advance Sten
×
×
  • Create New...