Hey fellow builders
I hoped my first post here would be a positive one with some awesome prints, but unfortunatly my new umo+ printer does not work..., I hope you guys can help me or give some tips.
(I have contacted support yesterday, but haven't heard from them yet)
I had a lot of fun building the unit, but I have not yet printed out a single correct Ultirobot print :(
Despite all the efforts of: lubricating, axis aligning, pulley checking, loosening the end-caps, reinstalling the newest firmware and cura, new gcode exports and making sure if the printhead can move without to much friction.
(advised by this site: http://support.3dverkstan.se/article/23-a-visual-ultimaker-troubleshooting-guide#shifted)
The problem is the stepper motor, it was quite noticeable because it produces a clogging/low clicking sound when it shuts down for cooling down and messes up the print. 3dverkstan advice is to lower the current to the stepper motors. But I can not find this option in the ulticontroller menu so I presume I am overlooking the option... where can i find it?
Is there another way of avoiding the overheating part?
I really appreciate any help you can provide.
(no weird printer settings, just a "High" quickprint profile with PLA. as requested by the manual for making your first print)