Coopoon

Thanks mate, will give it a go and let you know how I get on! Cheers

Labern, Thanks of the guide load of stuff there! Checked all the belts and pulleys but looks like is issue with the stepper motors overheating and shutting down to cool while printing, have looked that up and seems to be a common problem. Trying to see if adjusting the current to the motor works if not will try to install some fan cooling or heatsink addition.

I seem to be having a issue when printing taller prints. The stl file looks fine in Cura but when printing the printer moves off the original start point and print creeps off line. Any idea what is going wrong?

Thanks for the tips gr5! Was using PLA and bed was default at 60 deg, was using glue but will try the wet wipe next time with the brim setting Tried this afternoon printing again while watching and it started to candy floss but noted was not extruding properly, so think it missed a layer or 2 then was printing in thin air. Did a Atomic clean and has been fine so far.

Just got my new printer and have been printing off a few bits and bobs everything was good, until the other day was printing off a larger item, left unit running over night and in the morning found the machine full of candy floss! The print was supposed to be about 200mm heigh but only got to 20mm before started misprinting. Anyone have an idea what is going wrong? Still new so haven't changed any settings. Thanks,