UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Thanks Robert! I did get the nozzle cleaned up using a blunt knife to scrape it.
The fan shroud was a bit easier as the PLA came off as a single piece once heated.
I had left the printer online for a print overnight, by morning the print was stuck on the nozzle with PLA coating the entire heater block and also stuck inside the fan shroud.
Looking for suggestions on cleaning it up.
Thanks