Jump to content

Mirobieb

Dormant
  • Posts

    2
  • Joined

  • Last visited

Everything posted by Mirobieb

  1. Hi, We have an Ultimaker Original+ that has a tendency to jam, because the plastic part of the delrin wheel shifts sideways on the metal bearing until it's pressed up against the wall, and no longer turns. This causes underextrusion or even for the print to fail entirely. There is no real pattern to how often this happens, sometimes it'll print fine for ages and sometimes it will go wrong three times in a row. It's easy to push the plastic wheel back into the centre so it turns again, but I would really rather it just stays there. Other than replacing the delrin wheel, is there anything I can do to stop this happening?
  2. We have a brand new UMO+. The first prints looked fine, but we probably made an error when we putted the nozzle in the heather block. Now it's leaking filament above the heather block. I tryed to fix it. But because there's filament every were I can't get it loose or tighter. Is there a trick to solve this problem. I think I have to get it all loose en clean it and then put it together again. But i can't get it loose Mirobieb
×
×
  • Create New...