Jump to content

BrayChristopher

Member
  • Content Count

    161
  • Joined

  • Last visited

3D Print posted by BrayChristopher

  1. Fail

    This is the first bad print I have had in a long time, and it sure was spectacular.
    It was an over night print that went out of control.
    Luckily all I had to do was heat up the nozzle and pull the blob off. Clean up the tip a bit and started a new print.
    I was really surprised that this didn't caused a nozzle clog.

    1,480 downloads

       (0 reviews)

    0 comments

    Updated

  2. I think it is a tooth

    3D Universe brand PLA
    210C nozzle
    60C bed

    1,248 downloads

       (0 reviews)

    0 comments

    Submitted

  3. Random Shroud

    This is a random part for a machine at work.
    We were very impressed how it turned out since it has thin walls and big overhangs.
    I used the FAST settings in S3D with a few modifications.
    The filament is 3D Universe PLA.

    1,493 downloads

       (0 reviews)

    0 comments

    Updated

  4. Ultimaker 2 Breathable Electronics Enclosure

    I wanted an enclosure for the UM2 that allowed the electronics to breathe more.
    I had a hard time getting this to work. At first I tried to put all of the holes in the bottom face in the part model. But all those little perimeters made it difficult to print.
    So I made the bottom side of the enclosure solid in the model.
    In the slicer software (S3D), I set the number of top and bottom layers both to zero. And I set the number of shells to 10.
    It didn't print perfect, but it printed better than any of my previous attempts.

    408 downloads

       (0 reviews)

    0 comments

    Updated

×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!