Jump to content
Ultimaker Community of 3D Printing Experts
  • Sign Up

BrayChristopher

Dormant
  • Content Count

    161
  • Joined

  • Last visited

3D Print posted by BrayChristopher

  1. Fail

    This is the first bad print I have had in a long time, and it sure was spectacular.
    It was an over night print that went out of control.
    Luckily all I had to do was heat up the nozzle and pull the blob off. Clean up the tip a bit and started a new print.
    I was really surprised that this didn't caused a nozzle clog.

    1,480 downloads

       (0 reviews)

    0 comments

    Updated

  2. Random Shroud

    This is a random part for a machine at work.
    We were very impressed how it turned out since it has thin walls and big overhangs.
    I used the FAST settings in S3D with a few modifications.
    The filament is 3D Universe PLA.

    1,493 downloads

       (0 reviews)

    0 comments

    Updated

  3. I think it is a tooth

    3D Universe brand PLA
    210C nozzle
    60C bed

    1,248 downloads

       (0 reviews)

    0 comments

    Submitted

  4. Ultimaker 2 Breathable Electronics Enclosure

    I wanted an enclosure for the UM2 that allowed the electronics to breathe more.
    I had a hard time getting this to work. At first I tried to put all of the holes in the bottom face in the part model. But all those little perimeters made it difficult to print.
    So I made the bottom side of the enclosure solid in the model.
    In the slicer software (S3D), I set the number of top and bottom layers both to zero. And I set the number of shells to 10.
    It didn't print perfect, but it printed better than any of my previous attempts.

    408 downloads

       (0 reviews)

    0 comments

    Updated

×
×
  • Create New...