Jump to content

Reggie

Dormant
  • Content Count

    2
  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. I recently installed a more recent version of cura from the website 15.06.01. We were originally using a version that wasn't running the new uranium framework, 15.01 I believe. I'm not sure if it's the update itself that has caused this or if it is one of the apprentice's at work changing settings on the preferences to be quite honest.
  2. Hi there, I've recently been having issues with the support structures while printing parts at work. The support structures have become very difficult to remove and the surface finish of areas that are supported by the support structures has become highly uneven as you will see below: This issue has only started recently, on parts we have previously printed successfully, and on both of our ultimakers, therefore I am assuming it must be one the settings that has been changed in CURA that has caused the problem... but I'm not sure what it could be. Any words of wisdom would be appreciated!
×
×
  • Create New...