Jump to content
Ultimaker Community of 3D Printing Experts

Waynicus

Member
  • Content Count

    3
  • Joined

  • Last visited

Community Reputation

0 Neutral

About Waynicus

  • Birthday 01/09/1978

Personal Information

  1. Thanks for that Bob It's a job and a half to strip it down from what I can tell. I've packed the lead screw with Magnalube and dialled the printer in a bit more. It's a little better but I think at some point I need to replace the lead screw and brass bush.
  2. Hi Bob How did you get on with replacing it? I've got some play with the lead screw and motor. Thanks Wayne
  3. Also just used some ICE filaments PET and in a way nice to see someone having similar issues as me although I've not yet tried reducing the travel speed so will give that a go. I'm not finding the material very strong though, was printing at 225°C and 25mm/sec. Have you had any further success since you posted the above? Thanks, Wayne
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!