Strik9

Thanks i'll try that!

When i wrote manually extruding, i was referring to the option where you can spin the wheel, to extrude filament, not me pushing I've tried the atomic cleansing, and it was already clean. Tomorrow i'll try to open the feeder to see if there's nothing wrong here, and make sure the tension is correct.

I actually have the same problem, usually after a few prints. At some point it will do the same thing and now filament will go out of the nozzle. Even i manually extrude within the option it still do the same thing. I've tried to factory reset in case someone has changed parameters, print with normal setting in Cura i still have the problem.

Ah, i was also looking for this option

Still not in the 15.06.03 or i can't find the option?