Jump to content

Jables

Dormant
  • Content Count

    2
  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. This is that blackish silhouette I was talking about
  2. So I tested a few things.... They might be somewhere in this thread. The favorite settings isn't yet working. They just copy the last adjusment you make to favorite. The Post-Processing didn't work. I set mine to pause at 3 mm, but it just continued. The Cut-off Object Bottom is improved out of the two tests I was running, one of them has failed and the other has succesfully printed from the point where I said it had to print. In the new cura 15.0 you have said that the saving works way better than before. If I want to save everything which stands on my bed, I have to make a selection, out of everything, and then I can only save selection to file instead of save all.... I had a few times my software was mirrored somehow and a few seconds later it's normal again. When I´m in layered mode and I would like to move one of my objects, a blackish silhouette of my object comes out and the object itself doesn´t move at all. When saying how much time it would take to print this object, the counter would say 6:35 m, which I thought would be 6 minutes and 35 seconds. But later I found out it meant 6 hours and 35 minutes. Though I do have to say that I can manipulate multiple objects at once, which is nice when working with scales and such. I hope to give you enough information and futhermore I hope that I haven't said to much that already has been said. Thanks in advance
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!