[Cura 15.10 Open Beta]

 

This is that blackish silhouette I was talking about

[Cura 15.10 Open Beta]

So I tested a few things.... They might be somewhere in this thread.

The favorite settings isn't yet working. They just copy the last adjusment you make to favorite.

The Post-Processing didn't work. I set mine to pause at 3 mm, but it just continued.

The Cut-off Object Bottom is improved out of the two tests I was running, one of them has failed and the other has succesfully printed from the point where I said it had to print.

In the new cura 15.0 you have said that the saving works way better than before. If I want to save everything which stands on my bed, I have to make a selection, out of everything, and then I can only save selection to file instead of save all....

I had a few times my software was mirrored somehow and a few seconds later it's normal again.

When I´m in layered mode and I would like to move one of my objects, a blackish silhouette of my object comes out and the object itself doesn´t move at all.

When saying how much time it would take to print this object, the counter would say 6:35 m, which I thought would be 6 minutes and 35 seconds. But later I found out it meant 6 hours and 35 minutes.

Though I do have to say that I can manipulate multiple objects at once, which is nice when working with scales and such.

I hope to give you enough information and futhermore I hope that I haven't said to much that already has been said. Thanks in advance