Hi,
I just installed an E3Dv6 hotend on my UM2 using this mount https://www.youmagine.com/designs/e3d-integrated-printhead-v1-9. Everything works quite well except a few minor details:
Whenever I start the load material routine and when I start a print, the print head runs into axles because the head is slightly larger in both the x+ and y+ directions. I have spend quite some time googling to find out how to change the firmware to avoid these issues, but I have not been able to find anything useful - could someone point me in the right direction?
Thank you in advance,
Gregers Poulsen