Hi,
I am new in 3d printing.
I got some heavy stringing with one model even with lowering temperature to 190C and increasing travel speed, as shown on picture.
After reading about how to minimize it, i set Retraction minimum travel = 0, Enable combing = all,
Minimal extrusion before retracting = 0 and lowered print speed to 40mm/s.
I got sliced layers in CURA on attached image. Some of them are pretty clear , but a lot of them still have blue lines
getting over gaps , some even without retracting.
Is it possible to force avoiding holes like 100%, because on this model it is possible, and cleaning stringing after pretty impossible? Any suggestions?
setup cura, i3Hephestos, colorfab PLA
Thanks