UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Received the heater today, installing tomorrow.
At first sight, as clumsy as I am: the heater has two bare ends .... how the fxxx do I install this?
The replacement of the sensor was rather easy with the 'plug' at the end ....
Oh boy ...
yo Bob-Hepple,
thank you for the reply.
I 've put the fans completely off. So this might not be the reason.
Printing PLA was no problem but trying to print HIPS at higher temp resulted in error messages.
Today I've contacted the seller and he told me that the error might occur when having the Olsson block installed. He will send me a 35W heater.
yo, thx for your reply.
As I inspected my frans several times: no fran shroud touches the block.
Tomorrow I will reinstall the block.
But I cannot understand that printing PLA = perfect with block, printing with HIPS = error.
In the dutch community somebody told me I need a 35W heater to solve the problem.
https://ultimaker.com/en/community/18820-olsson-block-en-foutmelding?page=unread#unread
Yo Marrut, bedankt voor je toelichting.
Hoewel een PLA print wel lukte begon ik helemaal te twijfelen aan mezelf.
Zal eerstdaags mijn verkoper contacten.
THX
hallo,
Heb olsson block geïnstalleerd en succesvol een PLA print uitgevoerd.
Bij het laden van HIPS krijg ik volgende foutmelding:
https://drive.google.com/open?id=0B5Cw6Ud9eoUlTFYwUFZHYVpPY1k
Kan iemand de situatie verduidelijken?
thx
Hello,
Installed Olsson block and made succesfully a PLA print.
Now, inserting HIPS I get error message as shown in picture below.
Please, what happens?
https://drive.google.com/open?id=0B5Cw6Ud9eoUlTFYwUFZHYVpPY1k
yo Titus, bedankt voor je reply.
Heb es bekeken en zoals gedacht: ik had deze niet anders ingesteld.
Waarschijnlijk was het een voorteken dat de nozzle verstopt zat. Nozzle gereinigd en geen probleem meer.
yo MMsoft, bedankt voor je reply.
Heb zeker en vast geen instellingen gewijzigd: ben ik heel zeker van. Na het posten van mijn bericht heb ik een print opgestart en de nozzle was verstopt: geen druppel pla meer. Waarschijnlijk was het uitblijven van de contour een voorteken. Nozzle gereinigd en de contour komt weer tevoorschijn.
Yo,
heb sedert een week UM2.
In het begin werd bij aanvang van een print de contour geprint, zoals aangegeven op de site.
Echter, bij de laatste prints is dit niet meer het geval.
Probleem?