Hello! I started printing with a new Ultimaker 2 Extended about two weeks ago and frequently the printer just "finishes" the prints far too early. At times it will be in the middle of a section while saying "x Hours Remaining" and then just stop, saying "Printer Cooling Down" and leaving me with a half-finished irritation. About a week ago I did upgrade this model to support the Olsson Block, and during this change I ended up having to replace the temperature sensor. I've seen that occasionally temperature sensor errors can stop/prevent a print, but as of now I have not seen any error codes at all, let alone ones pertaining to the sensor.
I'm curious as to whether or not this would be a hardware issue or a issue in Cura. I've been looking at the settings and the software defaults to "Print one at a time" mode, often saying prints are too tall, even ones with just a single item. I've found that changing this setting to "Print all at once" and resaving the g code, even if its a print with only one object, will cause it to correct this problem but this doesn't seem right. Would this be an issue with the g code that's saved on the SD card? Possibly an issue with Cura settings? Unseen hardware error? Any help would be appreciated and thank you guys in advance!