Thanks for you reaction Yellowshark,
I use an Ultimaker2 without door. Ambient temperature is around 15°
All settings are the same as before, I even restored the factory settings to be sure.
I did not change any fan settings.
Now I cleaned the printbed with dry paper, that was already better but still the object moved.
The print bed temperature is 60°
I do not use any adhesive or spray or tape yet since it worked fin without wit PLA on the glass plate.
I calibrated the nozzle distance, that must be OK.
I am going to try the Atomic Method. It is very well possible that carbonised material is left because the day before the printer kept printing all night without material...
Thanks again. I will inform about the result.
Kind regards
Axel