Jump to content

BrookeWinslow

Dormant
  • Posts

    1
  • Joined

  • Last visited

Everything posted by BrookeWinslow

  1. Hello, I know this thread hasn't been active in years, but I am learning how to use Taulman Bridge filament and am experiencing very similar problems that you describe higher up in the print. I have many thin diameter branching pieces to my print and they tend to get hit by the print head as they warp, causing burned parts of the print, printing in empty air, messy printing, etc. I will try lowering the printing temp and using some fan to see if there is an improvement, as was suggested in the thread. Since this topic started, have there been any new strategies you've learned to decrease the warping higher up in the print? Thank you! Brooke
×
×
  • Create New...