Jump to content
Ultimaker Community of 3D Printing Experts

JohnQuinn

Member
  • Posts

    3
  • Joined

  • Last visited

Personal Information

  • Country
    ZA

JohnQuinn's Achievements

0

Reputation

  1. Hi, Correction - meter was set to A/C after checking in D/C mode voltage is correct, 24.1V. Today disassembled the hot end and all looks OK no burned wires inside.
  2. Update - checked power supply and found 52.5 V? Examined board no burned areas.
  3. While printing at 260C the machine suddenly shut down and I thought it was a fuse in the plug source, but when checked there was still power at the power supply and the DC plug to printer. Any suggestions what to check next? Machine is all black no power up.
×
×
  • Create New...