Jump to content

dvdmcd

Dormant
  • Posts

    2
  • Joined

  • Last visited

Personal Information

  • Country
    CA

dvdmcd's Achievements

1

Reputation

  1. thanks for the reply izzy, I'm still using the original nozzle ill look into upgrading it however, i cleaned it using the pull method to no effect, also i tuned up the heat, again no difference. I'll try the flow rate and heat together, also since the first layer prints normally could it have something to do with the z axis moving down to far on each increment? thanks again for your help!
  2. Top surface has a weave/ cross hatching appearance. I have been printing for about a year now on these settings. It has been going great; however for no apparent reason the top surfaces now has a distinct cross hatching finish. On thinner prints you can see light through the piece. Any suggestions as to what could be causing this would be very helpful. Thanks [/media]
×
×
  • Create New...