Good afternoon all,
I just installed the olsson block to our Ultimaker 2 and attached the 0,25 nozzle.
I printed at first the ultimaker robot with normal settings (normal quality - quick settings out of cura)
The Result is the Robot on the left - i think this is very bad quality.
After this i leveled the bed once again and changed the temperature to 220°C (printing the standard grey PLA from Ultimaker)
Thickness is 0,1mm
Wall thickness is 0,5mm
Retraction is on
Infill 0,6mm
20%
Speed 20mm/s
Nozzle 0,25
First layer 0,18mm
Air Gap 100%
What do you think i can tune to get a better result, i still see some "lines" at the back.
Thanks for your help!
Best regards