Jump to content

barelko_com

Dormant
  • Posts

    1
  • Joined

  • Last visited

Personal Information

  • Country
    KZ

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

barelko_com's Achievements

2

Reputation

  1. Hi guys, maybe my experience will help someone. So, I've spend a lot of time to solve temperature fluctuation and error type: MINTEMP err I cursed AD597 - huge amount of electric noise was collected by a thermocouple, when I turned on stepper motors that was unacceptable at all, also problem will rise when you have not good power supply with big high frequency noise. I will skip my all attempts with wrong wiring etc how its was says on many forums, so the main error in wrong datasheet and controller AD597 design itself. The solution is simple - Instead of grounding pin (8) of chip, you must include a (pull-down) resistor, 10k-100k, between minus thermocouple pin and the ground. This greatly decreased the electric-noise-induced current picked by the thermocouple, improving your accuracy to about +/-0.1C. Also I put 4,7mF ceramic capacitor to filter +5V and I used 0.22uF ceramic capacitor in OUT signal, that improved my accuracy to at least +/- 0.02C. A brief note, different types of capacitors do differ. For low pass filters, use ceramic! My handdrawn pics and mods photos included!
×
×
  • Create New...