Jump to content

RoboWizards

Member
  • Content Count

    4
  • Joined

  • Last visited

Everything posted by RoboWizards

  1. I am running CURA 3.6.18 on Windows 10. I am trying to modify the bed temperature settings before exporting to gcode. In my interface under "Manage Profiles..." I am unable to modify the bed temperature even when I duplicate the profile. Is there another place on the GUI that I need to look for this?
  2. That seemed to allow the computer to connect to the printer. When I ran a print though something was wrong with the settings. It did not seem to be moving at the correct speed. Should I try to manipulate the expert settings? I am using a TAZ 5 and there is no profile for that model, only TAZ and TAZ mini.
  3. Thanks for the advice. I will get to that tomorrow. Am I using the best version of Cura for my system?
  4. Installed Cura successfully and loaded model. When I open control it cannot connect to TAZ 5. Any known issues that might be the cause of this? or suggestions?
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!