RoboWizards
-
Posts
4 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by RoboWizards
-
-
That seemed to allow the computer to connect to the printer. When I ran a print though something was wrong with the settings. It did not seem to be moving at the correct speed. Should I try to manipulate the expert settings? I am using a TAZ 5 and there is no profile for that model, only TAZ and TAZ mini.
-
Do you belong to the group "dialout"?
http://wiki.ultimaker.com/Installing_Cura_on_Linux
https://www.lulzbot.com/learn/tutorials/cura-lulzbot-edition-installation-debian (scroll down to "Troubleshooting")
Thanks for the advice. I will get to that tomorrow.
Am I using the best version of Cura for my system?
-
Installed Cura successfully and loaded model. When I open control it cannot connect to TAZ 5. Any known issues that might be the cause of this? or suggestions?
Modifying Bed Temperature in Settings
in Improve your 3D prints
Posted
I am running CURA 3.6.18 on Windows 10. I am trying to modify the bed temperature settings before exporting to gcode. In my interface under "Manage Profiles..." I am unable to modify the bed temperature even when I duplicate the profile. Is there another place on the GUI that I need to look for this?