UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Hallo Dieter,
ich kann nur Onshape] empfehlen. Wenn man sich die Einführungsvideos anschaut kommt man schnell damit klar. Ist zwar alles auf Englisch, aber relativ selbsterklärend.
Beste Grüße
Patrick
Hallo,
ich kann mich Gerd nur anschließen, versuch mal bei 0,3 mm Schichthöhe die Temperatur auf 220°C zu erhöhen. Der Kunststoff der nach dem Extrudieren in das Hotend geschoben wird muss entsprechend schnell erwärmt werden.
Beste Grüße
Patrick