Jump to content
Ultimaker Community of 3D Printing Experts


  • Content Count

  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • Country
  1. Thank you for your quick replies! I was wondering if this affects the printing quality (as well as the belt lifetime) so I think I will fix this.
  2. Hello Forum I noticed that the long belts are rubbing against some of the pulleys. The rods are not moving back and forth, the pulley are close to the black spacers, no play at all. For me this does not look very healthy for the belts, albeit the rubbing seems not to be too bad (no grinded belt particles on the bottom nor twisted belts). If I would put the pulleys in a line with the belt, so the belts wouldn't rub anymore against the pulleys, the rods would move back and forth. Should I place washer between the black spacers and the pulleys to fix this problem? Or is it negligible? And: Does this effects the print quality? Thank you very much, Martin

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!