Predator75

ok I do same 3D prints for test, I think this best the way Thank you anyway Cristian

Thank you nallath, and sorry for my bad english, my fault. There is the plugin named "skip infill" here http://wiki.ultimaker.com/CuraPlugin:_Skipinfill that print to fill every "n" layer. so for example, I can print 0.1 but infill 0.2 it's ok? it works with bottn and top layer also? Is that plugin compatibile with cura 15.04.x ? is it possibile to view a preview result?, because in preview if I use tha plugin the preview layer don't change Excuse my bad english Cristian

ok if I set top/bottom tickness to 0, the layer wil not printed. where I wrong?

Thank you I'll try!

Hi, is it possibile to upgrade the plugin Skip Infill to apply to the Bottom/Top layer also? regards Cristian