Jump to content
Ultimaker Community of 3D Printing Experts
  • Sign Up

jrm7997

New member
  • Content Count

    1
  • Joined

  • Last visited

Everything posted by jrm7997

  1. Good morning I've done some research on this and am getting better at figuring out this machine. I have a stock Ultimaker 2 and have about 10 hours of use on it. I am using PLA. My problem is that the size of the extruded cylinder of PLA is very small (picture attached) and if you look closely there are times it looks sputtered (?). When the PLA comes out of the nozzle it comes out on an angle. It kind of curls out. I have done numerous atomic cleanings and readjusted the bed twice. My research here and on the pictorial "problems" doc don't show what my printer is doing. Am i right to think this is a plugged nozzle? And are my clues to this, the thin extrude and or the direction the fluid comes out the right way to be looking at this? I would think the PLA should squeeze straight out of the nozzle. Thanks in advance
×
×
  • Create New...