Bmklawt

I'm printing a pipe in a spiral and it's taking forever, Cura says it should take 10 hours, it's hour 13 and it's not yet half done. I notice that the hot end always stays over the part the problem is when it Rapids to another section of the pipe it follows the inside wall off pipe to the center the back out the out side wall until it gets to where it's going extrudes a tiny bit the jumps to another section and repeat this endlessly. How do stop it from doing this, I don't care if it Rapids over empty space. The part is a 1/2" solid pipe the spirles out to 9", like a lollipop. Your help is greatly appreciated.