Jump to content

Protofabrica

Member
  • Posts

    1
  • Joined

  • Last visited

Personal Information

  • 3D printer
    Ultimaker 2
  • Country
    PH
  • Industry
    Education
    (Product) design
    Engineering
    R&D / Exploration

Protofabrica's Achievements

0

Reputation

  1. [/media] Just bought an Innofil 3D PLA 2.85mm filament by "accident" because the supplier I contacted didn't have any Ultimaker filaments anymore. Anyway, tried it and fortunately, it works just as good as the ones supplied by Ultimaker themselves. I kept using the same settings I used for the Ultimaker PLA 2.85mm filaments: no glue on heated bed, 60degrees heat of the bed, 200-210degrees heat for the hot end. As seen on the photos attached, the orange marvins are from Ultimaker and the green marvins are from Innofil 3D.
×
×
  • Create New...