I noticed my prints coming out bad and realized my side fans had stopped working. I reset my UM2 to factory settings and reset Cura settings as well. This did not help, so I ordered new fans. I have installed my new fans and they are not working either. If I set the fan speed to 50% on my UM2 and blow on them to get them started turning, they will keep spinning, just at a very low speed, so I think they are getting a little power. Also, I normally do not print with my LED lights on but noticed today that they are not working either. If I have the LED settings at 100%, they have a very low (like 5%) light output, so they seem to be getting some power too, but maybe not enough? I am worried there might be a problem with the control board, but I am not sure what to do from here. I have taken the bottom panel off to look at the connections and they are good. Any ideas? Thanks.
-UK